Volkswagen Tiguan Service and Repair Manual: High-Mounted Brake Lamp
High-Mounted Brake Lamp Bulb -M25-
High-Mounted Brake Lamp Bulb -M25-, Removing and Installing
Special tools and workshop equipment required
- Trim Release Lever - Wedge -T10039/1-
Note
- Faulty LED(s) in the high-mounted brake lamp:
- Individual LEDs (Light Emitting Diodes) in high-mounted brake lamp are
combined into groups of up to 3 LEDs and are supplied with power as a group.
- If one LED should fail, the other LEDs will be loaded even more and will
fail soon.
- If one LED group is faulty (3 individual LEDs), the legally required
brightness set forth by the Economic Commission for Europe it still met.
- If more than 3 individual LEDs are faulty, the legally required
brightness will no longer be meet and the high-mounted brake lamp must be
replaced.
Removing
- Switch off the ignition and all electrical consumers and remove the
ignition key.
- Tape off the area above the brake lamp with tape
-1-.
- Insert the Trim Release Lever - Wedge -T10039/1--1-
at the top between the High-Mounted Brake Lamp Bulb -M25--2-
and the rear lid.
- Release the retainer for the High-Mounted Brake Lamp Bulb -M25- by
pushing the wedge -1- in the drive direction.
- Remove the High-Mounted Brake Lamp Bulb -M25- from the rear lid. Pay
attention to the wires still connected.
- Unlock the retainers -2- in the direction
of -arrow A- and push the compact connector
-1- out of the holder in the direction of
-arrow B- at the same time.
- Push the retainer -1- in the direction of
-arrow- and pull the connector
-2- out upward.
Installing
Install in reverse order of removal. Note the following:
Note
Make sure the seal for the High-Mounted Brake Lamp Bulb -M25- fits correctly.
Seal should not warp any straps and must not be damaged.
- Connect the compact connector and push it onto the holder on the bulb
body.
- Install the high-mounted brake lamp into the rear lid and make sure it
is secure.
- Check the functionality of the High-Mounted Brake Lamp Bulb -M25-.
Side Panel Tail Lamps
General Information
Note
Additional information:
Refer to Self Study Program; No 404; The Tiguan.
Refer to
→ Wiring diagrams, Troubleshooting & Component location ...
License Plate Lamp -X-
License Plate Lamp -X-, Removing and Installing
Special tools and workshop equipment required
Torque Wrench 1783 - 2-10Nm -VAG1783-
Removing
Switch off the ignition and all ...
See More:
Volkswagen Tiguan Owners Manual > Rear hatch: Opening the rear hatch
Fig. 29 In the remote control vehicle
key. Button to unlock and open the rear hatch.
Fig. 30 Opening rear hatch from the
outside.
Read and follow the introductory information and
safety information first⇒Introduction
to the subject Always remove any item(s) being transported on the rea ...
Volkswagen Tiguan Owners Manual
Volkswagen Tiguan Service and Repair Manual
© 2018-2024 Copyright www.vwtiguan.org - 0.0945