Volkswagen Tiguan Owners Manual: Hubcap

Volkswagen Tiguan Owners Manual / Do it yourself / Wheel covers / Hubcap

Fig. 189 Pulling off hubcap.

Read and follow the introductory information and safety information first⇒

Introduction to the subject

To remove Take the wire clip out of vehicle tool kit and hook it into the edge of the hubcap ⇒ Fig. 189 .

Pull the hubcap off in the direction of the arrow.

To install Press hubcap against the rim until it latches.

The hubcaps are designed to protect the wheel bolts and should be firmly reinstalled after the wheel change.

Introduction to the subject

In this chapter you will find information on the following subjects:⇒ Hubcap ⇒ Wheel cover ⇒ Wheel bolt caps More information: Exterior care and cleaning ⇒ Exterior care and clea ...

Wheel cover

Fig. 190 Pulling the wheel cover off. Read and follow the introductory information and safety information first⇒Introduction to the subject Pulling off the wheel cover Take the lug wrench ...

See More:

Volkswagen Tiguan Service and Repair Manual > Drive Axles, Removing and Installing: Drive Axles with Triple Roller Joint AAR3300i, Mounted in Transmission, Removing and Installing
Special tools and workshop equipment required Drive Axle Wedge Tool -T10161- Drive Shaft Remover -T10520- Torque Wrench 1332 40-200Nm -VAG1332- Caution When disassembling and performing repairs on a vehicle, the drive axles must not hang down loosely and contact the stops in the joint by over ...