Volkswagen Tiguan Owners Manual: Break-in period

Volkswagen Tiguan Owners Manual / Care, cleaning, maintenance / Parts, accessories, repairs and modifications / Break-in period

Read and follow the introductory information and safety information first⇒Introduction to the subject

Note applicable requirements for breaking in new parts.

Breaking in a new engine

A new engine must be carefully broken in during the first 1000 miles (1600 kilometers). During the first few hours of driving, the engine's internal friction is higher than later when all moving parts have been broken in.

Engine life is influenced by how you drive the vehicle for the first 1000 miles (1600 km). Even afterwards, driving at moderate engine speeds, especially when the engine is cold, will tend to reduce engine wear and help the engine to last longer and go farther. But do not drive at an excessively low engine speed, either. Always downshift if the engine is not running smoothly. For the first 600 miles (1000 km):

Do not use full throttle.

Don't let the engine speed get above 2/3 of the maximum speed.

Do not tow a trailer.

From 600 to 1000 miles (1000 to 1600 km): Speed may gradually be increased to maximum permissible road and engine speed.

New tires and brake pads

New tires and replacing tires ⇒ Tires and wheels

Brakes ⇒ About the brakes

Breaking in a new engine gently, will increase service life and reduce oil consumption.

Introduction to the subject

In this chapter you will find information on the following subjects:⇒ Break-in period ⇒ Parts and accessories ⇒ Operating fluids and equipment ⇒ Repairs and technical modifications ...

Parts and accessories

Read and follow the introductory information and safety information first⇒Introduction to the subject Volkswagen recommends that you consult an authorized Volkswagen dealer or authorized Vol ...

See More:

Volkswagen Tiguan Service and Repair Manual > Clear Coats: Two-Part HS Optimum Clear Coat
Definition: Two-Part HS Optimum Clear Coat -LZK 769 K02 A5- Product Description Two-part HS optimum clear coat is a VOC compliant (VOC value less than 420 g/L), high-quality and productive high solid clear coat. Properties: Easy and economical processing Very good spreading properties Dries ...