Read and follow the introductory information and
safety information first⇒
Introduction
to the subject
| Please perform these steps only in the order listed. | ||
|---|---|---|
| Step | Vehicles without Keyless Access | |
| 1. | Automatic transmission: Depress the brake pedal and hold it down until step 4 is completed. | |
| 1a. | Manual transmission: Depress clutch pedal fully and hold until the engine has started. | |
| 2. | Shift the transmission into Neutral (N) or Park (P) (automatic), or into Neutral (manual only). | |
| 3. | Turn the vehicle key to position ⇒ Fig. 127② – do not depress the accelerator pedal. | |
| 4. | When the engine starts, release the remote control vehicle key. | |
| 5. | If the engine does not start, stop the procedure and start again after about one minute. | |
| 6. | Release the electronic parking brake when you are ready to start driving ⇒ Braking, stopping, and parking . | |

Warning

WarningStarting fluids can explode and can cause a run-away vehicle condition.

Note

Do not let your vehicle warm up while standing; instead, start driving right away after making sure that you have good visibility through all windows. This will help the engine reach operating temperature faster and keep down emissions.

Major consumers of electricity are temporarily switched off when the engine is being started.

After starting a cold engine, there may be increased operating noises for a few seconds. This is normal and harmless.
Applicable only in the United States
Starting the engine
Stopping the engineVolkswagen Tiguan Service and Repair Manual > Exterior Lights, Switches: Ignition/Starter Switch and Lock Cylinder
Steering Lock Housing
Steering Lock Housing, Removing and Installing
Caution
Always follow the procedure as described in the Repair Manual when
disconnecting and connecting the battery.
Note
To remove the steering lock housing, remove the steering column switch base
carrier first.
Caution
The st ...