Volkswagen Tiguan Owners Manual: Fuses in the vehicle

Volkswagen Tiguan Owners Manual / Do it yourself / Fuses / Fuses in the vehicle

Fig. 197 On the driver side in the instrument panel: Fuse box cover.

Fig. 198 In the engine compartment: Fuse box cover.

Read and follow the introductory information and safety information first⇒

Introduction to the subject

Replace a blown fuse only with a fuse of the same amperage (same color and same imprint) and same overall size.

Fuse color coding

Color	Current strength in amps
Purple	3
Light brown	5
Brown	7,5
Red	10
Blue	15
Yellow	20
White or clear	25
Green	30
Orange	40

Opening the fuse box in the instrument panel

Open storage compartment and pull back firmly in the direction of the arrow ⇒ Fig. 197 .

Opening the fuse box in the engine compartment

Open the engine hood ⇒ .

Move the release tabs in the direction of the arrows to unlock the fuse box cover ⇒ Fig. 198 .

Remove the cover upward.

To install push the cover onto the fuse box. Move release buttons back opposite the direction of the arrows, until they audibly latch.

Note

To help prevent vehicle damage, be careful when removing fuse box covers and be sure to reinstall them properly.

Open fuse boxes must be protected from dirt and moisture. Dirt and moisture in fuse boxes can cause damage to the electrical system.

The vehicle contains other fuses in addition to those mentioned in this section. Have these fuses replaced by an authorized Volkswagen dealer or an authorized Volkswagen Service Facility.

Introduction to the subject

In this chapter you will find information on the following subjects:⇒ Fuses in the vehicle ⇒ Replacing blown fuses Due to ongoing development of the vehicle, configuration-dependent allo ...

Replacing blown fuses

Fig. 199 Illustration of a blown fuse. Fig. 200 Removing or inserting a fuse using the plastic tweezers. Read and follow the introductory information and safety information first⇒Introduction ...

See More:

Volkswagen Tiguan Service and Repair Manual > Wheels, Tires, Wheel Alignment: Driver Assistance Systems Front Camera -R242-
General Information Note If the camera can no longer recognize the lane markings due to poor visibility, this could be caused by: The camera visual field is dirty or icy. If that is the problem, it should be corrected. The camera view field in fogged over. If the camera lens is obstructed by ...