Volkswagen Tiguan Owners Manual: Tire inflation pressure in cold tires

Volkswagen Tiguan Owners Manual / Care, cleaning, maintenance / Tires and wheels / Tire inflation pressure in cold tires

Read and follow the introductory information and safety information first⇒Introduction to the subject

Drive train	Tire dimensions	Tire pressures
Drive train	Tire dimensions	psi	kPa	bar
Front-wheel drive	215/65 R16	35	240	2.4
	235/55 R17	35	240	2.4
	235/50 R18	35	240	2.4
	255/40 R19	38	260	2.6
	T145/80 R18^a)	61	415	4.1
Four-wheel drive (4MOTION)	215/65 R16	38	260	2.6
	235/55 R17	38	260	2.6
	235/50 R18	38	260	2.6
	255/40 R19	41	280	2.8
	T145/80 R18^a)	61	415	4.1
xl = reinforced sidewall.
The Tire Pressure Monitoring System is configured at the factory with the correct tire inflation pressure applicable for the vehicle model, engine and factory-installed tires. The tire inflation pressure is listed on the tire inflation pressure label on the driver door jamb ⇒ Tire inflation pressure . The tire inflation pressures for the road tires are listed on this label. The inflation pressure for the compact spare is as specified on the tire pressure label or on a separate label for the compact spare, if there is one. In the event of a discrepancy between the above figures and the tire pressures listed on the tire inflation pressure label, the pressures listed on the label are the ones you should use.

^a) Compact spare wheel

Tire inflation pressure

Fig. 171 Location of the tire inflation pressure label. Read and follow the introductory information and safety information first⇒Introduction to the subject The correct tire inflation pres ...

Tread depth and tread wear indicators

Fig. 172 Tread pattern: Wear indicator. Read and follow the introductory information and safety information first⇒Introduction to the subject Tread depth Most driving situations require as m ...

See More:

Volkswagen Tiguan Service and Repair Manual > Gears, Shafts: Input Shaft
Overview - Input Shaft Note Warm the toothed gear to approximately 100 ºC (212 ºF) using Inductive Heater -VAS6414-. Wear protective gloves. Install all input shaft bearings with transmission fluid. Replace grooved ball bearing after removing. Circlip For grooved ball bearing/input sh ...