Volkswagen Tiguan Owners Manual: Pedals

Fig. 130 Pedals in vehicles with manual
transmission: ① Accelerator pedal, ② Brake pedal, ③ Clutch pedal.

Fig. 131 Pedals in vehicles with automatic
transmission: ① Accelerator pedal, ② Brake pedal.
Read and follow the introductory information and
safety information first⇒

Introduction
to the subject
All pedals must always be able to move freely in and out without
interference from floor mats or other things.
Only use floor mats that leave the pedal area free and are held securely in place
with floor mat fasteners to help prevent sliding.
If a brake circuit malfunctions, more brake pedal travel is needed to bring the
vehicle to a full stop, and it is important that nothing is in the way when you
have to depress the brake pedal harder and farther than normal.

Warning
Objects in the driver footwell can prevent the pedals from moving freely. This can
cause loss of vehicle control and increase the risk of serious personal injuries.
- Always make sure that nothing can interfere with the pedals.
- Always fasten floor mats securely to the floor.
- Never put floor mats or other floor coverings on top of already installed
floor mats.
- Always make sure that nothing can fall into the driver footwell while the
vehicle is moving.

Note
Always make sure that the pedals are able to move freely and that nothing can interfere
with them. If a brake circuit fails, more brake pedal travel will be needed to bring
the vehicle to a stop. The brake pedal must be pressed farther and harder than normal.
Read and follow the introductory information and
safety information first⇒Introduction
to the subject
Lights up
Possible cause
Proper response
B ...
Fig. 132 Gearshift pattern of a 6-speed
manual transmission.
Read and follow the introductory information and
safety information first⇒Introduction
to the subject The positions of the indiv ...
See More:
Tesla Model Y (2020-2023) Owner's Manual > Lights: Turn Signals
The turn signals flash three times or continuously, depending on how far up
or down you move the stalk. Lightly push the turn signal stalk up or down for a
three-flash sequence. For a continuous signal, push the stalk fully up or down.
The turn signals stop operating when canceled by the steerin ...