Fig. 203 In right front bumper: Removing light assembly.
Fig. 204 Replacing light bulb in headlight.
Please carry out each step only in the order specified: | |
---|---|
1. | Please review and follow the checklist ⇒ Information on light bulb replacement . |
2. | Remove the wire bracket from the vehicle tool kit and secure it in the opening in the cover ⇒ Fig. 203 . Pull the cover upward in the direction of the arrow. |
3. | Remove the screw ⇒ Fig. 203① using the screwdriver in the vehicle tool kit ⇒ Vehicle tool kit . |
4. | Remove the headlight. |
5. | Release the connector ⇒ Fig. 204① and disconnect it. |
6. | Turn the bulb holder ⇒ Fig. 204② counterclockwise in the direction of the arrow until it stops and remove it toward the rear with the bulb. |
7. | Replace the burned out light bulb with a new bulb of the same type. |
8. | Insert the bulb holder into the headlight assembly and turn it clockwise until it stops. |
9. | Connect the connector ⇒ Fig. 204① on the bulb holder ⇒ Fig. 204② . You must hear the connector click into place. |
10. | Insert the headlight. |
11. | Tighten the screw ⇒ Fig. 203① with the screwdriver. |
12. | Install cover in the bumper ⇒ Fig. 203 . |
Volkswagen Tiguan Owners Manual > Changing a wheel: Lifting the vehicle with the vehicle jack
Fig. 194 Lift points for the jack.
Fig. 195 Jack in position at the left
rear lift point.
Read and follow the introductory information and
safety information first⇒Introduction
to the subject The jack must be positioned at one of the four lift points marked
on the vehicle body (2 on ea ...