Fig. 132 Gearshift pattern of a 6-speed manual transmission.
Read and follow the introductory information and safety information first⇒Introduction to the subject The positions of the individual gears are shown on the gearshift lever ⇒ Fig. 132 .
The clutch pedal must be fully depressed to start the engine.
Shifting into reverse
Downshifting
You should always downshift gear by gear when driving, meaning always into the next lowest gear. Do not downshift when the engine rpm (revolutions per minute) is too high ⇒ . At fast speeds or high engine rpms, skipping over one or more gears when downshifting can cause damage to the clutch and transmission, even if a gear is not engaged ⇒ .
Warning
Downshifting to a lower gear incorrectly can result in loss of vehicle control and can cause accidents and serious personal injuries.Warning
When the engine is running and a gear is engaged, the vehicle will start to move as soon as the clutch pedal is released, even when the parking brake is applied. This also applies when the parking brake is engaged.
Note
Shifting down to a gear that is too low when driving at fast speeds or high engine rpms can cause extensive damage to the clutch and transmission. That is true even if the clutch pedal is pressed so that the clutch is not engaged.Note
To help prevent damage and premature wear:
Volkswagen Tiguan Service and Repair Manual > Refrigerant R134a Servicing: Refrigerant Circuit, Detecting Leaks
Searching for Refrigerant Circuit Leaks with Compressed Air or Nitrogen
Note
This repair manual describes different methods for detecting leaks in
the refrigerant circuit. These methods have been tested and result in
success when used correctly.
If when searching for compressed air / Nitrogen ...